| Interval | Service | Details |
|---|---|---|
| Every 50 hours | Lubrication Points | Lubricate boom linkage and cylinder pivot points every 50 hours; lubricate Quik-Tatch mounting plate latches every 50 hours |
| Every 300 hours | Engine Oil & Filter | Break-in after first 100 hours; then every 200 hours. When using John Deere filter and Plus-50 oil, interval is 300 hours. |
| Every 500 hours | Fuel Filter | Drain water and sediment from fuel filter every 10 hours; replace both in-line fuel filter and fuel water separator filter every 500 hours or annually |
| Every 500 hours | Hydraulic Fluid & Filter | Change hydraulic oil filter after first 10 hours; change hydraulic oil filter every 500 hours or annually. Check the operator's manual for the hydraulic oil type. |
| Every 1,000 hours | Air Filter | Primary air cleaner element: every 500 hours or annually; secondary air cleaner element: every 1000 hours |
Change the oil in the John Deere 333G every 300 hours of run time. Because it is measured in engine hours, log the hour-meter reading rather than a date.
The John Deere 333G is serviced on engine hours, not miles. Key intervals include Lubrication Points (every 50 hours), Engine Oil & Filter (every 300 hours), Fuel Filter (every 500 hours). Track the hour meter and service each item when its interval comes due.
By hours. Small engines and heavy equipment log run time on an hour meter, so their service intervals are hours-based. ServiceSage Auto tracks the John Deere 333G by hours and reminds you when each service is due.