| Interval | Service | Details |
|---|---|---|
| Every 25 hours | Brake Pads and Basic Checks | Every 25 hours or 250 miles (400 km): inspect the brake pad wear and the parking brake pads (if equipped) (dealer; the pad service limit is 0.030 in (0.76 mm)), turn the key on to pressurize the fuel pump and check the lines and fittings for leaks and abrasion, inspect and adjust the parking brake cable (if equipped), inspect and clean the engine breather, and check, clean and test the battery terminals. |
| Every 50 hours or 6 months, whichever comes first | Engine Oil & Filter | Change the oil and filter every 50 hours, 500 miles (800 km) or 6 months, whichever comes first, after a break-in change at 25 hours or one month. Polaris marks it to be done more often in severe use: frequent mud, water or sand, racing or high-RPM use, long low-speed heavy loads, extended idle, or short cold-weather trips. If the oil level rises in cold weather, change the oil right away. Polaris PS-4 5W-50 4-cycle oil, or PS-4 Extreme Duty 10W-50 for 0 to 120 F (-18 to 49 C); capacity 2.5 qt (2.4 L). |
| Every 50 hours | 50-Hour Service | Every 50 hours or 500 miles (800 km): lubricate all fittings, pivots and cables; inspect the throttle pedal (dealer) and throttle body intake ducts; inspect and adjust the shift cable or linkage; lubricate the steering (dealer, if applicable) and the front and rear suspension (if applicable); inspect the engine oil lines and fasteners and the shock absorbers. Check coolant strength seasonally and pressure test the cooling system yearly (dealer). |
| Every 50 hours | Drive Belt and Clutches | Inspect the drive belt (replace as needed) and the drive and driven clutches (clean, replace worn parts) every 50 hours or 500 miles (800 km). Dealer-recommended. Polaris gives no fixed belt replacement interval. |
| Every 100 hours | Front Gearcase Lubricant | Change every 100 hours or 1,000 miles (1,600 km); check and top up every 25 hours or 250 miles (400 km), starting at the 25-hour break-in. More often in severe use. Polaris Demand Drive Fluid, 8.5 oz (250 ml). |
| Every 100 hours | Transmission Lubricant (AGL) | Change every 100 hours or 1,000 miles (1,600 km); check and top up every 25 hours or 250 miles (400 km), starting at the 25-hour break-in. More often in severe use. Polaris AGL Gearcase Lubricant and Transmission Fluid, 44 oz (1,300 ml). |
| Every 100 hours | 100-Hour Service | Every 100 hours or 1,000 miles (1,600 km), on top of the 50-hour items: check for fuel leaks at the fill cap, fuel line or rail and fuel pump (dealer); inspect the spark plugs, replace as needed and torque to spec (dealer); clean the radiator's outside surfaces; inspect and pressure test the cooling hoses; torque the engine mounts; inspect the exhaust silencer and pipe and the wiring; inspect the front wheel bearings (dealer) and the cam chain tensioner. |
| Every 200 hours | Valve Clearance | Inspect and adjust as needed at the 200, 400 and 500 hour services (2,000, 4,000 and 5,000 miles); after 500 hours the chart starts again from the 25-hour service. Dealer-recommended. |
| Every 500 hours | Spark Plug Replacement | Replace at the 500 hour or 5,000 mile (8,000 km) service and torque to spec (dealer); the plugs are inspected every 100 hours. NGK MR7F, gap 0.7-0.8 mm, torque 7 ft-lb (10 Nm). |
| Every 500 hours or 5 years, whichever comes first | Coolant | Replace the coolant at the 500 hour or 5,000 mile (8,000 km) service, and drain the system completely and refill it every 5 years however few hours it has run; more often in severe use. Check the coolant strength seasonally and pressure test the system yearly. Polaris Antifreeze 50/50 Premix; capacity 6.08 qt (5.75 L). |
| Every 500 hours | Toe Adjustment | Inspect the toe adjustment at the 500 hour or 5,000 mile (8,000 km) service, with the spark plugs and coolant (dealer); Polaris says to inspect it periodically and adjust it when parts are replaced. After 500 hours the chart starts over at the 25-hour service. |
| Every 2 years | Brake Fluid | Change every two years, and any time the fluid becomes contaminated. DOT 4 brake fluid. Dealer-recommended. |
Change the oil in the Polaris RZR XP 4 1000 every 50 hours of run time or every 6 months, whichever comes first. The first change is at 25 hours or one month, at the end of the break-in, and Polaris asks for it more often in severe use: mud, water, sand, high RPM, heavy loads or short cold-weather trips. Because it is measured in engine hours, log the hour-meter reading rather than a date.
The Polaris RZR XP 4 1000 is serviced on engine hours, miles or months, whichever comes first. Key intervals include Engine Oil & Filter (every 50 hours or 6 months), Spark Plug Replacement (every 500 hours), 50-Hour Service (every 50 hours). Track the hour meter and service each item when its interval comes due.
The Polaris RZR XP 4 1000 engine takes 2.5 qt (2.4 L) of oil. Oil type: Polaris PS-4 5W-50 4-cycle oil (PS-4 Extreme Duty 10W-50 for 0 to 120 F).
The break-in period is the first 25 hours or two full tanks of fuel: no full throttle or high speed for the first 3 hours, and only moderate braking for the first 50 stops. Break in the drive belt by driving at slower speeds with light loads for the first 50 miles (80 km), or in low gear for the first 5 miles (8 km) in sand, dunes or mud. At 25 hours or one month: break-in engine oil and filter change, first level checks on the front gearcase and transmission (top up if needed), and a parking brake cable adjustment (if equipped), plus the regular 25-hour checks.
By hours, miles or months, whichever comes first: Polaris's manual gives most services an hour and a distance figure, and many a calendar limit too. ServiceSage Auto tracks the Polaris RZR XP 4 1000 by engine hours and months and reminds you when each service is due; the schedule notes give the manual's mileage figures.