Arctic Cat Prowler Pro Maintenance Schedule

Arctic Cat Prowler Pro maintenance — the short answer

  • Oil: 0W-40 synthetic (any API SM 0W-40 oil is acceptable) · about 2.37 L (2.5 US qt)
  • Oil change interval: every 200 hours
  • Engine: 4-stroke, liquid-cooled
  • Tracked by: engine hours, not miles

Arctic Cat Prowler Pro maintenance schedule by engine hours

IntervalServiceDetails
Every 100 hoursAir Filter Outer ElementInspect the engine air filter outer element every 100 hours or 1,000 miles (1,600 km) and replace it as necessary.
Every 100 hours100-Hour ChecksEvery 100 hours or 1,000 miles (1,600 km): check the fluid levels and grease the rear knuckles.
Every 200 hoursEngine Oil & FilterChange the engine oil and filter every 200 hours or 2,000 miles (3,200 km), after the first change at 50 hours or 500 miles (800 km), the last break-in service. Arctic Cat recommends 0W-40 synthetic oil; any API SM 0W-40 is acceptable. Capacity about 2.37 L (2.5 US qt). Filter 14.8-18.4 ft-lb (20-25 N-m), drain plug 36.9 ft-lb (50 N-m).
Every 200 hoursSpark PlugsEvery 200 hours or 2,000 miles (3,200 km): check the gap, clean the plugs and replace them as necessary. F6RTC (Arctic Cat p/n 3040-031), gap 1.0 mm (+/- 0.1 mm), tightened to 14.75 ft-lb (20 N-m).
Every 200 hoursAlternator BeltReplace the alternator belt every 200 hours or 2,000 miles (3,200 km).
Every 200 hoursCVT Belt and Clutch InspectionEvery 200 hours or 2,000 miles (3,200 km): inspect the CVT belt, the drive and driven clutches and the CVT air inlet, and check the clutch engagement speed (about 1,200-1,300 RPM); replace the belt and worn clutch parts as necessary; clean the air inlet and blow the clutches out with compressed air.
Every 200 hoursSpark ArrestorInspect and clean every 200 hours or 2,000 miles (3,200 km), and replace it as necessary.
Every 200 hoursRadiator CleaningClean the radiator every 200 hours or 2,000 miles (3,200 km).
Every 200 hours200-Hour ChecksEvery 200 hours or 2,000 miles (3,200 km): have the dealer check the brake pad wear; tighten any loose hardware; check and clean the battery terminals; check the sway bar links and bushings and replace them as necessary; torque the wheel nuts to 100 ft-lb (136 N-m); inspect and clean the shocks and springs.
Every 400 hoursAir Filter Inner ElementEvery 400 hours or 4,000 miles (6,400 km): inspect the engine air filter inner element and replace it as necessary, and inspect and clean the air filter intake hose.
Every 400 hoursTransaxle FluidReplace every 400 hours or 4,000 miles (6,400 km), after the first change at 50 hours or 500 miles (800 km). Transaxle Fluid with EP; capacity 1.21 L (41.0 fl oz), filled to the bottom of the fill hole. Drain and fill plugs 16 ft-lb (21.8 N-m).
Every 400 hoursFront Differential FluidReplace every 400 hours or 4,000 miles (6,400 km), after the first change at 50 hours or 500 miles (800 km). SAE 80W-90 hypoid; capacity 198 ml (6.7 fl oz). Drain plug 45 in-lb (5 N-m), fill plug 16 ft-lb (21.8 N-m).
Every 400 hoursRubber Lines and HosesInspect the rubber lines and hoses every 400 hours or 4,000 miles (6,400 km) and replace them as necessary.
Every 500 hoursValve LashCheck the valve lash clearance every 500 hours or 5,000 miles (8,000 km) (dealer).
Every 2 yearsBrake FluidReplace the brake fluid every 24 months.
Every 2 yearsCoolantReplace the engine coolant every 24 months. Capacity 6.54 L (6.92 US qt).

Arctic Cat Prowler Pro specifications

  • Type: UTV / Side-by-Side
  • Engine: 4-stroke, liquid-cooled
  • Displacement: 812 cc
  • Oil type: 0W-40 synthetic (any API SM 0W-40 oil is acceptable)
  • Oil capacity: about 2.37 L (2.5 US qt)
  • Spark plug: F6RTC, gap 1.0 mm

Arctic Cat Prowler Pro items without a fixed hour interval

  • Break-In: During the first 2.5 hours use less than 40% throttle; for the next 2.5 hours run at 40-60% with short bursts up to wide open, and vary the engine speed. Torque the wheel nuts to 100 ft-lb (136 N-m) at 10 hours or 100 miles (160 km) and again at 50 hours or 500 miles (800 km). At 50 hours or 500 miles: check the fluid levels and replace the engine oil and filter, the transaxle fluid and the front differential fluid. New brake pads must be burnished before they reach full braking power.
  • Daily Checks: Before each ride, run the Pre-Start/Pre-Operation Checklist: brake pedal, brake fluid level, pad wear and leaks; steering, shift lever and accelerator; coolant, oil, fuel and differential levels and leaks; ball joints, tie rod ends and shocks; lights and switches; air filter clean-out valve and ducting; tire pressure, tread, wheels and rims; seat belts; nuts, bolts, latches and the ROPS. Arctic Cat also says to check the cooling system daily for leaks, look over each shock every week, and maintenance-charge a battery that sits unused for more than two weeks.
  • Manual Used: From Arctic Cat's 2023 Prowler Pro operator's manual (Base, XT and LTD). Other model years were not checked; if your own manual differs, follow it.

Frequently asked questions

How often should I change the oil in an Arctic Cat Prowler Pro?

Change the oil in the Arctic Cat Prowler Pro every 200 hours of run time. The first change is at 50 hours or 500 miles (800 km), the last break-in service. Because it is measured in engine hours, log the hour-meter reading rather than a date.

What is the maintenance schedule for an Arctic Cat Prowler Pro?

The Arctic Cat Prowler Pro is serviced on engine hours, miles or months, whichever comes first. Key intervals include Engine Oil & Filter (every 200 hours), Air Filter Outer Element (every 100 hours), Air Filter Inner Element (every 400 hours). Track the hour meter and service each item when its interval comes due.

How much oil does an Arctic Cat Prowler Pro take?

The Arctic Cat Prowler Pro engine takes about 2.37 L (2.5 US qt) of oil. Oil type: 0W-40 synthetic (any API SM 0W-40 oil is acceptable).

What is the first (break-in) service on an Arctic Cat Prowler Pro?

During the first 2.5 hours use less than 40% throttle; for the next 2.5 hours run at 40-60% with short bursts up to wide open, and vary the engine speed. Torque the wheel nuts to 100 ft-lb (136 N-m) at 10 hours or 100 miles (160 km) and again at 50 hours or 500 miles (800 km). At 50 hours or 500 miles: check the fluid levels and replace the engine oil and filter, the transaxle fluid and the front differential fluid. New brake pads must be burnished before they reach full braking power.

Does the Arctic Cat Prowler Pro track maintenance by hours or miles?

By hours, miles or months, whichever comes first: Arctic Cat's manual gives most services an hour and a distance figure, and many a calendar limit too. ServiceSage Auto tracks the Arctic Cat Prowler Pro by engine hours and months and reminds you when each service is due; the schedule notes give the manual's mileage figures.