| Interval | Service | Details |
|---|---|---|
| Every 50 hours | Greasing | Apply a small amount of multi-purpose grease to the grease fittings (VHT link, A-arms, parking brake lever, cargo lift cylinder pivot, range gear shift link, battery terminals, etc.) every 50 hours; lubricate more often in extremely wet and muddy conditions. |
| Every 50 hours | Engine Start System Check | Test the range gear shift lever safety switch every 50 hours in H, L, and R positions; the engine must not crank when a control lever is out of neutral. |
| Every 100 hours | Muffler/Spark Arrester Clean | Clean and inspect the swirl-type spark arrester every 100 hours by tapping the muffler while raising and lowering engine revolution to purge carbon particles. |
| Every 100 hours | Wheel Fastener Torque Check | Check wheel bolt torque every 100 hours, especially when new; retighten to specified torque (aluminum wheel 90-110 N-m, steel wheel 108-130 N-m) if loose. |
| Every 100 hours | Battery Condition Check | Check battery condition every 100 hours by reading the indicator or with a voltmeter/hydrometer. If used less than 100 hours per year, check the battery condition annually instead. |
| Every 100 hours | Alternator Belt Tension Adjust | Check and adjust alternator belt tension every 100 hours; proper deflection is 7 to 9 mm (0.28 to 0.34 in) at the middle of the span. |
| Every 100 hours | VHT Neutral Spring Check | Check that engine speed returns to idle immediately after releasing the speed control pedal every 100 hours. Consult your local Kubota Dealer if it does not respond immediately. |
| Every 100 hours | VHT Pressure Release Check | Check the VHT unload link/rod clearance every 100 hours after starting and quickly shutting off the engine. Consult your local Kubota Dealer if clearance is out of specification. |
| Every 100 hours | Toe-In Adjust | Adjust toe-in every 100 hours; proper toe-in is 5 to 15 mm (0.2 to 0.59 in), with the front distance shorter than the rear distance. |
| Every 100 hours | Fuel Filter Check | Check the fuel filter every 100 hours for clogging by debris or water contamination; replace if found. Fuel lines should also be checked every 1 year. |
| Every 100 hours | Air Cleaner Primary Element Clean | Clean the air cleaner primary element every 100 hours; clean more often in dusty conditions. Replace the element with a new one even if it has not been used for 1 year if carbon or oil adheres to it. |
| Every 200 hours | Engine Oil Filter Replace | Replace the engine oil filter every 200 hours. Use only a Kubota genuine filter to prevent serious engine damage. |
| Every 200 hours | Engine Oil Change | Change engine oil every 200 hours (4.1 L / 4.3 US qts with filter exchange, or 3.8 L / 4.0 US qts without). |
| Every 200 hours | Transmission Oil Filter (VHT, Yellow) Replace | Replace the yellow VHT transmission oil filter every 200 hours. Use only a Kubota genuine filter to prevent serious transmission damage. |
| Every 200 hours | Transmission Oil Filter (Suction, Black) Replace | Replace the black suction transmission oil filter every 200 hours. Use only a Kubota genuine filter to prevent serious transmission damage. |
| Every 200 hours | Brake Pedal Check | Check brake pedal free travel (8 to 18 mm / 0.3 to 0.7 in) and pedal stroke (less than 150 mm / 5.9 in) every 200 hours; contact your local Kubota Dealer for adjustment if out of specification. |
| Every 200 hours | Parking Brake Adjust | Adjust the parking brake lever every 200 hours; proper free play range is 1 notch. |
| Every 200 hours | Brake Light Switch Check | Check that the brake light comes on when the brake pedal is depressed every 200 hours; check the bulb or switch if it does not. |
| Every 200 hours | Front Brake Case Check | Check the front brake case for brake fluid leaks every 200 hours; consult your local Kubota Dealer if a leak is found. |
| Every 200 hours | Hydraulic Tank Oil Change | Change the hydraulic tank oil every 200 hours (18.0 L / 19.0 US qts); drain the tank via the drain plug behind the seat/utility box and refill to the upper dipstick line. |
| Every 200 hours | Inner Air Filter Clean | Clean the inner (cab/AC) air filter every 200 hours by blowing air opposite the normal air flow direction, or soaking in mild detergent water if very dirty. |
| Every 200 hours | Air Conditioner Condenser Check | Check the air conditioner condenser is clean of debris every 200 hours. |
| Every 200 hours | Air Conditioner Drive Belt Adjust | Adjust air conditioner belt tension every 200 hours; proper deflection is 10 to 12 mm (0.4 to 0.48 in) under a 98 N (10 kgf) load. |
| Every 300 hours | Tire Wear Check | Check tires for damage, cracking, bulging or excessive wear every 300 hours; replace or repair at once if found, and replace when tread depth reaches minimum allowable (3 mm / 0.12 in). |
| Every 400 hours | Transmission Fluid Change | Change the transmission (hydraulic) fluid every 400 hours (7.0 L / 1.8 US gal); clean the magnet plug of metal filings at the same time. Run the engine at medium speed after refilling before operating the vehicle. |
| Every 400 hours | Front Axle Case Oil Change | Change the front axle case oil every 400 hours (0.6 L / 0.6 US qts). |
| Every 400 hours | Knuckle Case Oil Change | Change the front knuckle case oil on both sides every 400 hours (0.25 L / 0.26 US qts per side). |
| Every 400 hours | Fuel Filter Replace | Replace the fuel filter every 400 hours. Consult your local Kubota Dealer for this service; this is a registered emission-related critical part. |
| Every 800 hours | Engine Valve Clearance Adjust | Have the engine valve clearance adjusted every 800 hours. Consult your local Kubota Dealer for this service. |
| Every 1,000 hours | Air Cleaner Primary Element Replace | Replace the air cleaner primary element once yearly or every 1000 hours, whichever comes first. |
| Every 1,000 hours | Air Cleaner Secondary Element Replace | Replace the air cleaner secondary (safety) element once yearly or every 1000 hours, whichever comes first. Do not touch the secondary element except when replacement is required. |
| Every 1,500 hours | Fuel Injection Nozzle Pressure Check | Have the fuel injection nozzle injection pressure checked every 1500 hours. Consult your local Kubota Dealer for this service; this is a registered emission-related critical part. |
| Every 2,000 hours | Cooling System Flush | Flush the cooling system every 2000 hours or 2 years, whichever comes first, using cooling system cleaner per the cleaner's instructions. |
| Every 2,000 hours | Coolant Change | Change the coolant every 2000 hours or 2 years, whichever comes first (7.9 L / 8.3 US qts); use a 50/50 mix of ethylene glycol long-life coolant and clean soft water. |
| Every 3,000 hours | Injection Pump Check | Have the injection pump checked every 3000 hours. Consult your local Kubota Dealer for this service; this is a registered emission-related critical part. |
Change the oil in the Kubota RTV-X1100C every 200 hours of run time. Because it is measured in engine hours, log the hour-meter reading rather than a date.
The Kubota RTV-X1100C is serviced on engine hours, not miles. Key intervals include Greasing (every 50 hours), Engine Start System Check (every 50 hours), Muffler/Spark Arrester Clean (every 100 hours). Track the hour meter and service each item when its interval comes due.
By hours. Small engines and heavy equipment log run time on an hour meter, so their service intervals are hours-based. ServiceSage Auto tracks the Kubota RTV-X1100C by hours and reminds you when each service is due.