Simpson Aluminum Water Blaster ALWB60825 Maintenance Schedule

Simpson Aluminum Water Blaster ALWB60825 maintenance — the short answer

  • Oil: SAE 10W-30, API SG or newer (chart also allows 5W-30 in cold and SAE 30 in hot weather) · 39 oz (1.1 L)
  • Oil change interval: every 100 hours or 6 months
  • Engine: CRX 420 4-stroke OHV, single-cylinder, air-cooled, 9.0 kW at 3600 rpm (SAE J1349 net), carbureted, low-oil shutdown; belt drive (two 3VX375 belts) to an AAA C4X-series triplex plunger pump (Simpson part 530021) with external unloader and thermal relief valve; 4400 PSI at 4.0 GPM
  • Tracked by: hours of use, not miles - Simpson lists no hour meter for this model, so keep a run-time log

Simpson Aluminum Water Blaster ALWB60825 maintenance schedule by engine hours

IntervalServiceDetails
Every 50 hours or 3 months, whichever comes firstClean Air FilterClean the air cleaner every 3 months or 50 hours, whichever comes first - more often in dusty or dirty conditions. Unscrew the wingnut, remove the cover and element, clear the dirt and debris out of the housing, refit the element and cover. The engine manual gives no replacement interval for the element.
Every 100 hours or 6 months, whichever comes firstEngine Oil ChangeChange the engine oil after the first month or 10 hours, then every 6 months or 100 hours, whichever comes first (and before each season). SAE 10W-30, API SG or newer, for general all-temperature use; the manual's chart also allows 5W-30 in cold weather and SAE 30 in hot weather. Capacity 39 oz (1.1 L) - fill to the upper limit on the dipstick. Drain it warm, with the engine level.
Every 100 hours or 6 months, whichever comes firstSpark Plug CheckInspect and adjust the spark plug every 6 months or 100 hours. Gap 0.024-0.031 in (0.6-0.8 mm); tighten to 15-18 ft-lb (20-25 N-m). Replace the plug or washer if damaged or worn; clean a reusable plug with a wire brush.
Every 100 hours or 6 months, whichever comes firstSpark Arrester CleaningClean the spark arrester every 6 months or 100 hours; replace it if damaged.
Every 100 hours or 3 months, whichever comes firstPump Oil ChangeChange the pump crankcase oil after the first 50 hours, then every 100 hours or 3 months. The AAA triplex pump takes SIMPSON Premium Pump Crankcase Oil (part 80138), or SAE 15W-40 if that is not available. Loosen the fill plug/vent cap, remove the drain plug, drain, refit the drain plug, and fill until the level meets - but does not exceed - the dot in the center of the sight glass. Neither manual prints a capacity.
Every 300 hours or 12 months, whichever comes firstSpark Plug ReplacementReplace the spark plug every year or 300 hours. The manual names no part number - use the recommended plug or an equivalent of the correct heat range (the wrong heat range can damage the engine). Gap 0.024-0.031 in (0.6-0.8 mm), 15-18 ft-lb.
Every 300 hours or 12 months, whichever comes firstIdle Speed Check and AdjustmentInspect and adjust the idle speed every year or 300 hours. The manual says this is for knowledgeable, experienced owners or an authorized dealer.
Every 300 hours or 12 months, whichever comes firstValve Clearance Check and AdjustmentInspect and adjust the valve clearance every year or 300 hours: intake 0.004-0.006 in (0.10-0.15 mm), exhaust 0.006-0.008 in (0.15-0.20 mm). For knowledgeable, experienced owners or an authorized dealer.
Every 2 yearsEvaporative System InspectionEvery two years, inspect the carbon canister, the carbon canister tube and the evaporative oil breather tube; replace the canister or its tube if damaged. For knowledgeable, experienced owners or an authorized dealer.

Simpson Aluminum Water Blaster ALWB60825 specifications

  • Type: Pressure Washer
  • Engine: CRX 420 4-stroke OHV, single-cylinder, air-cooled, 9.0 kW at 3600 rpm (SAE J1349 net), carbureted, low-oil shutdown; belt drive (two 3VX375 belts) to an AAA C4X-series triplex plunger pump (Simpson part 530021) with external unloader and thermal relief valve; 4400 PSI at 4.0 GPM
  • Displacement: 420 cm3
  • Oil type: SAE 10W-30, API SG or newer (chart also allows 5W-30 in cold and SAE 30 in hot weather)
  • Oil capacity: 39 oz (1.1 L)
  • Spark plug: Gap 0.024-0.031 in (0.6-0.8 mm), 15-18 ft-lb; the manual names no plug part number

Simpson Aluminum Water Blaster ALWB60825 items without a fixed hour interval

  • Pre-Use Inspection: Before each use: check the pressure washer for leaks, loose or damaged parts, missing guards and anything else that may affect operation, and make sure the air vents and cooling slots are clean and open. Clear dirt and debris from the cooling vents, exhaust and starter recoil area. Repair or replace damaged parts before use, and never try to repair a high-pressure hose.
  • Engine Oil Level Check: Before each use: with the unit level and the engine off, wipe the dipstick, rest it on the filler neck without threading it in, and read the level - it should be at the upper limit. The engine ships WITHOUT oil, so fill it before the first start. The low-oil sensor shuts the engine off when the level falls below the safe limit.
  • Air Filter Check: Before each use: inspect the air cleaner. Never run the engine without the air filter.
  • Pump Breather Cap (New Unit): First setup: the pump ships with a RED shipping plug in the top. Remove it with a bladed screwdriver and thread in the BLACK breather cap finger-tight before running the pump.
  • Water Inlet Filter Cleaning: Before each use: remove the inlet filter from the garden hose coupler, rinse both sides with a running garden hose, and refit it convex side out. Never run the pressure washer without the inlet filter.
  • Nozzle Inspection and Cleaning: Inspect the nozzles before use. A clogged nozzle makes the pump pulsate and can build excess pressure that damages the pump. To clean: engine off, water off, squeeze the trigger to relieve pressure, set the trigger lock, remove the nozzle, clear it with the nozzle cleaning tool, then flush it backward with a running garden hose for at least 30 seconds.
  • Hose, Gun and Pump Connections Lubricate: Regularly clean the hose, spray gun and pump connections and lubricate them with a thin film of lithium grease to prevent O-ring damage and leaks (the manual gives no interval).
  • Storage Preparation: Two months or less (or when freezing is expected): fill the tank and add fuel stabilizer, run the unit 10 minutes with water flowing (keep squeezing the trigger), shut off, relieve pressure and drain the high-pressure hose, let it cool, treat the pump with SIMPSON Pump Guard, and store it clean, dry and out of sun. More than two months: with the engine cool, drain the tank, lines and carburetor (drain screw at the bottom of the carburetor), change the engine oil, remove the spark plug, pour 0.5 oz (15 ml) of new oil into the cylinder and pull the recoil twice, refit the plug, drain the high-pressure hose, and use Pump Guard (recommended for any storage over 30 days or when freezing temperatures are expected). Freeze damage is not covered by the warranty.

Frequently asked questions

How often should I change the oil in a Simpson Aluminum Water Blaster ALWB60825?

Change the oil in the Simpson Aluminum Water Blaster ALWB60825 every 100 hours of run time or every 6 months, whichever comes first. On a new unit the first change is due after the first month or 10 hours. The engine ships without oil: it holds 39 oz (1.1 L) of SAE 10W-30, API SG or newer - fill to the upper mark on the dipstick. The AAA pump has its own crankcase oil, changed after the first 50 hours and then every 100 hours or 3 months. Simpson does not list an hour meter for this model, so keep a rough log of the hours you run it.

What is the maintenance schedule for a Simpson Aluminum Water Blaster ALWB60825?

The Simpson Aluminum Water Blaster ALWB60825 is serviced on engine hours, not miles. Key intervals include Engine Oil Change (every 100 hours or 6 months), Pump Oil Change (every 100 hours or 3 months), Spark Plug Replacement (every 300 hours or 12 months). Without an hour meter, log your run time and service each item when its interval (or its yearly limit) comes due.

Does the Simpson Aluminum Water Blaster ALWB60825 track maintenance by hours or miles?

By hours of run time, with a yearly limit on several items. Simpson does not list an hour meter for this model, so estimate its hours from a simple run-time log. ServiceSage Auto tracks it by hours and reminds you when each service is due.