Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) Maintenance Schedule

Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) maintenance — the short answer

  • Oil: SAE 30 or SAE 10W-30 detergent oil · 0.53 L (18 fl oz)
  • Oil change interval: every 50 hours or 12 months
  • Engine: Briggs & Stratton 140000-series 223 cc OHV, 10.00 ft-lb gross torque; engine 14D932-0110-F1 on the 21199 (recoil start), 14D935-0111-F1 on the 21200 and 21220 (electric start)
  • Tracked by: hours of use, not miles - Toro lists no hour meter for this model, so keep a run-time log

Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) maintenance schedule by engine hours

IntervalServiceDetails
Every 8 hoursEngine Oil Level CheckInspection only, not an oil change: check the level on the dipstick and top up as needed. Briggs & Stratton says every 8 hours; Toro says before each use or daily. Running with too little or too much oil can damage the engine.
Every 8 hoursMuffler Area, Controls & Air Intake Grille CleaningEvery 8 hours: clear grass and debris from around the muffler and controls and clean the engine's air intake grille - packed clippings near the muffler are a fire risk and block cooling air. Toro also says to clean clippings and dirt from under the deck after each use.
Every 25 hours or 12 months, whichever comes firstBattery Charging (electric start only)Electric-start models only (21200 and 21220) - the 21199 is pull-start and has no battery. The mower has no alternator, so charge the battery with the supplied charger: 24 hours before first use, then 24 hours every 25 hours of use, and again yearly or before storage. Toro's charging section also says monthly (every 25 starts) or as needed, and every 90 days if the mower is stored in a heated area. If it will not charge, check the 40 A plug-in fuse.
Every 50 hours or 12 months, whichever comes firstEngine Oil ChangeFirst change after 5 hours (break-in), then every 50 hours or yearly, whichever comes first. Oil only: Toro's oil-change procedure has no filter step, and the lubrication groups of both Briggs & Stratton engine parts lists (14D932-0110-F1 and 14D935-0111-F1) list no oil filter. Use SAE 30 or SAE 10W-30 detergent oil, API SJ or higher. Capacity 0.53 L (18 fl oz), but some oil stays in the crankcase: pour in about three quarters of that, wait 3 minutes, then top up to the dipstick mark. Drain by tipping the mower onto its side with the air filter up and the fuel tank empty.
Every 50 hours or 12 months, whichever comes firstAir Cleaner Cleaning (cartridge and pre-cleaner)Every 50 hours or yearly, whichever comes first, and more often in dusty conditions: tap the paper cartridge on a hard surface to knock the dirt out (Briggs & Stratton says not to use pressurized air or solvents on it), and wash the foam pre-cleaner in liquid detergent and water, then let it dry completely. Replace the cartridge if it is damaged or wet with oil or fuel. Check the filter before each use as well.
Every 50 hoursBlade-Drive System ServiceEvery 50 hours: remove the blade-drive cover and blow or brush out debris, then slide a 0.25 mm (0.010 in) feeler gauge or a piece of paper down behind the belt-tension spring. If there is a visible gap, tighten the adjusting bolt and nut until the paper barely slides - do not overtighten, which can damage the blade-drive belt. A cleaning and belt-tension adjustment; this mower has no grease points.
Every 50 hours or 12 months, whichever comes firstExhaust System ServiceEvery 50 hours or yearly, whichever comes first: make sure the linkage, springs and controls are clean, examine the muffler for cracks, corrosion or damage, and if a deflector or spark arrester is fitted, remove it and check it for damage or carbon blockage.
Every 200 hours or 12 months, whichever comes firstAir Filter ReplacementEvery 200 hours or yearly, whichever comes first, and more often in dusty conditions: replace the paper cartridge (Briggs & Stratton 795066) and the foam pre-cleaner (796254). The 200-hour figure is in both the Toro and Briggs & Stratton schedules; the yearly replacement is from the Briggs & Stratton engine manual, which Toro's manual refers you to.
Every 12 monthsSpark Plug ReplacementReplace the spark plug yearly (Briggs & Stratton engine manual; no hour interval is published). Plug: Briggs & Stratton 692051, gapped to 0.020 in (0.51 mm) and tightened to 180 lb-in (20 N-m / 15 ft-lb). Toro also says to inspect the plug when taking the mower out of storage and replace it if it is dirty, worn or cracked.
Every 12 monthsBlade Sharpen/ReplaceYearly: have dull or nicked blades sharpened and balanced, or replace them. Replace damaged, cracked, bent or worn blades right away - a blade is bent if the two A/B measurements differ by more than 3 mm (1/8 in). Tighten the blade bolts to 82 N-m (60 ft-lb). Toro also says to inspect the blades before each use and whenever the mower runs out of fuel.
Every 12 monthsFuel Filter ReplacementYearly: replace the in-line fuel filter (Briggs & Stratton 84005063). Drain the fuel tank first, release the hose clamps, pull the fuel lines off the filter, check the lines for cracks or leaks, fit the new filter and refit the clamps.
Every 12 monthsFuel System ServiceYearly: inspect the fuel lines, tank, cap and connections for cracks or leaks and replace damaged parts. Add fuel stabilizer at the last fill-up of the season.
Every 12 monthsCooling System ServiceYearly, and more often in dusty conditions: brush or wipe debris from behind the muffler and from the blower housing, muffler and cylinder area (no water). Briggs & Stratton says the cylinder cooling fins need partial disassembly to clean and should be examined and cleaned by an authorized Briggs & Stratton dealer.
Every 12 monthsEmpty Fuel Tank (Storage Prep)Before yearly storage, and before any repair that means tipping the mower: run the engine until it stops, restart it and run it until it will not start again. While the engine is still warm, change the oil. Then remove the spark plug, add about 30 ml (1 fl oz) of oil through the plug hole, pull the starter slowly to spread it, and refit the plug.

Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) specifications

  • Type: Lawnmower
  • Engine: Briggs & Stratton 140000-series 223 cc OHV, 10.00 ft-lb gross torque; engine 14D932-0110-F1 on the 21199 (recoil start), 14D935-0111-F1 on the 21200 and 21220 (electric start)
  • Displacement: 223 cc
  • Oil type: SAE 30 or SAE 10W-30 detergent oil
  • Oil capacity: 0.53 L (18 fl oz)
  • Spark plug: Briggs & Stratton 692051; gap 0.020 in (0.51 mm); torque 180 lb-in (20 N-m)

Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) items without a fixed hour interval

  • Blade-Stop Check (before each use): Before each use or daily: check the blade-brake-clutch - the blades should stop within 3 seconds of releasing the blade-control bar. A safety check in every edition of Toro's maintenance table.
  • Clean Under the Deck (after each use): After each use: clean grass clippings and dirt from under the mower deck.
  • Residential-Use Rating: Every edition of Toro's TimeMaster operator's manual says the mower "is intended to be used by residential homeowners". The Briggs & Stratton engine warranty counts any income-producing use as commercial use, and for some engine lines its commercial terms are much shorter than its consumer terms (as short as 3 months), so check the warranty for your engine before putting this mower on a landscaping crew.
  • First Services (new mower): One time on a new mower: change the engine oil after the first 5 hours (break-in); after that it is every 50 hours or yearly. Electric-start models (21200 and 21220): charge the battery for 24 hours before first use.

Frequently asked questions

How often should I change the oil in a Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family)?

Change the oil in the Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) every 50 hours of run time or every 12 months, whichever comes first. On a new mower, do the first change after 5 hours. There is no oil filter: refill with 0.53 L (18 fl oz) of SAE 30 or SAE 10W-30 detergent oil, API SJ or higher, to the dipstick mark. Toro does not list an hour meter for this model, so keep a rough log of the hours you run it.

What is the maintenance schedule for a Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family)?

The Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) is serviced on engine hours, not miles. Key intervals include Engine Oil Change (every 50 hours or 12 months), Air Filter Replacement (every 200 hours or 12 months), Spark Plug Replacement (every 12 months). Without an hour meter, log your run time and service each item when its interval (or its yearly limit) comes due.

Does the Toro TimeMaster 30 inch mower (Model 21199 / 21200 / 21220 family) track maintenance by hours or miles?

By hours of run time, with a yearly limit on several items. Toro does not list an hour meter for this model, so estimate its hours from a simple run-time log. ServiceSage Auto tracks it by hours and reminds you when each service is due.